
                                 EtherApe FAQ
                                       
    1. Why is one computer constantly changing names?
       You are running in ethernet mode. Switch to IP mode.
    2. Why can I only see computers on my own network?
       See question above
    3. The rpm package says it requires libdb2.so.2. Where can I find
       that file?
       Install the db2-devel package
    4. I can't see any text, just little squares. What gives?
       Go to preferences and change the text font. Make sure you save
       your changes
    5. What's the format for /etc/ethers?
       Just pairs of Ethernet addresses and names, like
       00:40:33:35:80:5F LAZARO
       00:40:33:35:80:6D NEBAJ
       00:C0:26:A2:58:FE ARGOS
    6. How do I find the ether address of an IP node?
       Here is an example:
       argos:~# ping lazaro
       PING lazaro.tattoine.es (192.168.1.1): 56 data bytes
       64 bytes from 192.168.1.1: icmp_seq=0 ttl=255 time=1.8 ms
       round-trip min/avg/max = 1.6/1.7/1.8 ms
       argos:~# arp lazaro
       Address HWtype HWaddress Iface
       lazaro.tattoine.es ether 00:40:33:35:80:5F eth0
       Of course, you can only do this for nodes in your network.
    7. How do I find the IP corresponding to an ether address?
       You could, for instance, use
       argos:~# tcpdump -f "ether src 00:40:33:35:80:5F" -n
       tcpdump: listening on eth0
       10:34:11.116930 192.168.1.1.7002 > 192.168.1.2.1031: P
       76753564:76753576(12)
       There you have it, the IP src is 192.168.1.1
    8. Hosts keep moving because they come and go... What can I do?
       Set node timeout to 0.
     _________________________________________________________________
   
   $Id: FAQ.html,v 1.10 2001/04/23 11:45:36 toledo Exp $
   
   [1]sourceforge 

References

   1. http://sourceforge.net/
